Assembly parameters

Click button to open Assembly parameters panel.

• Project name will be used by SprutCAM. MachineMaker uses Robot name as Project name by default. It is also possible to change project name from toolbar,

• Simulation resolution. Use low values to reduce simulation quality in SprutCAM for this projects.

• Reorientation mode

• Snap base to positioner

• Move CS with Robot base

• Swap Tool and Workpiece frames

• Arcs by default

  • Circles division

  • Minimal Arc Length

  • Maximal Arc Radius

  • Minimal distance between start and end points

• Flips by default

  • Flip A1

  • Flip A2

  • Flip A3

• Gouge detection tolerance by default

  • Units

  • Tolerance value